)
CT clamps new in our product range
Self-consumption systems are becoming bigger and bigger. For this reason, we have extended our product range to include special sizes of CT clamps for my-PV Power Meter.
What exactly does a CT clamp do?
A CT clamp measures the current flowing through the wire. It is installed around the phase at the grid feed-in point. my-PV Power Meter contains as standard three 60A transformers, which are sometimes too small due to the ever-increasing power of self-consumption systems.
New in our product range:
- CT Clamp 100 A for my-PV Power Meter / 3 pieces in a set for the 3 phases in the house
- CT Clamp 200 A for my-PV Power Meter / 3 pieces in a set for the 3 phases in the house
Instructions for correct commissioning can be found here:
CT clamps settings
my-PV Power Meter Operation Manual
More articles
){kind=logo}
Partner
Using dynamic electricity tariffs for heat – with SpottyDiscover how to optimize heat generation with dynamic electricity tariffs with my-PV and Spotty – with or without PV.
Read more...)
References
Energy Transition at the Winery: Photovoltaics Instead of Gas in South TyrolWinery cuts gas use with solar heat: my-PV enables smart water heating via surplus PV energy in South Tyrol.
Read more...)
References
School project brings solar heat to a townhouseHot water from an off-grid photovoltaic solution instead of an oil-fired heating system – a cost-effective alternative.
Read more...